Sweet Peas
Cut four petals after the same pattern, making one about one and
one-half inches and two one inch, then a small one for the center, or a
few knots of baby ribbon may be used for the center. Arrange the petals
in a natural-looking blossom.
More
-
Ribbon Rosettes
There are many different kinds of rosettes made from ribbon. Sometimes several loops of ribbon are made very close together and wound with thread as they are gathered. A very pretty rosette is made of narrow ribbon one-quarter of an inch wide. Many ... Ribbons
If soiled, they may be cleaned in gasoline or soap and water, using a brush. Do not rub or wring. Hang up to drip dry, or wind tightly around a bottle and leave to dry. Do not press until after twenty-four hours, if cleaned in gasoline. To produce e... Right Sidewrong Side
This stitch is made by taking a long stitch on right side and then a short back stitch on wrong side. Lap ends of crinoline one-fourth inch at finish, but do not turn ends under. ... Rosettes From Old Plumes
An old plume may be used to make trimming for a hat by cutting it from the quill with a very sharp knife or razor blade, retaining a small portion of the quill which will be sufficient to hold the feathers together. This should be sewed onto a fine ... Sailor Hat Frame
For convenience we will use the following dimensions: Width of brim, three inches; height of crown, three and one-half inches; length of crown tip, eight and one-half inches; width of crown tip, six and one-half inches, and headsize, twenty-four inc... Shaped Brim Foundation
The simplest shaped brim is the mushroom style. ... Sheer Materials
In covering with anything as sheer as georgette, it is advisable to line with some other material first. The color could be made deeper by using a lining of the same color, or made paler by lining with white. The lining should be fitted and sewed on... Small Wound Rose Of Fabric
Cut from a true bias a strip of material one inch wide and four inches long. Fold lengthwise through the middle. Turn the raw edges in on one end, and gather one-eighth inch from the edge along the raw edges. Draw the thread up to one inch and roll,... Sprung
An uncovered steel wire used to make halo brims; is sometimes sewed on edge of buckram or other fabric brims, if the hat is unusually wide, or if a brim is to be especially stiff. It is occasionally used as an edge wire on wire frames. ... Square Crown
A square crown is one having a flat top, or one only slightly rounded, with the sides slightly sloping in towards the top. A crown of this type three or three and one-half inches in height would be at least one and one-half inches smaller at the top... Square Crown For Wire Frame
Straighten the brace wire and cut four sticks or pieces long enough to reach from the base of the crown at the front up over the proposed crown to the base of the crown at the back, allowing eight inches for finishing. Cut and join a small circle ... Sticks For Brim
Straighten and cut four pieces of frame wire the length of the diameter of the brim plus three inches for finishing. Place one of these sticks across the headsize wire from front to back on the marks made by the pencil, allowing the ends to extend a... Straw Shapes
BRIM--Brush well to remove all the dust. If the brim is too wide, a few rows of braid may be removed from the edge, and the edge refinished with one or more rows of ornamental braid of the same color. If it seems necessary to use an edge wire, this ... Sweet Peas
Cut four petals after the same pattern, making one about one and one-half inches and two one inch, then a small one for the center, or a few knots of baby ribbon may be used for the center. Arrange the petals in a natural-looking blossom. ... Tailored Bow
This bow is usually made from a piece of ribbon which has both sides alike, although it may be made from any ribbon. A Knox tailored bow is made from gros-grained ribbon. Cut a small piece of buckram for a foundation to sew the ribbon on. This shoul... Tailored Lining
This lining is rather the most popular lining used. Large firms send their material away to be made up for their trade and the linings may be bought ready-made, but almost every one has pieces of silk which may be easily made into one of these linin... Tie
Smallest wire used in millinery; comes wound on spools. Is used to tie other wires, and in making hand-made flowers. Comes in black, white, and green. ... To Color Wire Frames
Wires come in both black and white. A white frame may be colored to match any sheer fabric used for its covering. It will be found to be more simple to color the frame after it is made. Any of the cold or soap dyes may be used. If these are not avai... To Cover A Close-fitting Or Rolled Brim
Place corner of material on top of brim at front and pin on the edge. Always use the same method of pinning on the edge as given in the first lesson. Draw the material down to the headsize wire and pin. Work the material out smoothly toward the left... To Cover A Crown With Braid
Begin at the bottom of the crown, slanting the second row off from the first row the same as on the brim. Pull the braid up with the thread (which will be found on the edge of nearly every braid) and sew until the center of the crown tip is reached,... To Cover A Mushroom-shaped Brim
If not very drooping, it may be covered without making a seam in the material. To do this, begin by placing the corner of the fabric on top at the front of the brim. Pin the front, back, and each side, always pulling with the thread of the material,... To Cover Brim
Place corner of velvet at front of brim on top side (smooth side). Edgewire and headsize wire should always be on top of brim. Turn velvet over edge of brim and pin. Stick pins through at right angles to brim to avoid marring the velvet. Pin closely... To Cover Crown Top
To cover the top, cut a piece of velvet with the bias at the front, same shape as top of crown plus one inch all around. Gather one-fourth inch from edge, place over top, equalize the gathers, pin in place, and sew with stab stitch over line of gath... To Cover Narrow Brim Sailor Without An Edge Seam
This method can be used satisfactorily only when the brim is narrow, and the fabric pliable. For convenience we will give measurements as for a two and one-half inch brim, flat sailor, outside edge measuring forty inches. Cut a bias piece of velvet ... To Cover Round Crown
Pin material on top of crown with bias at front. Pull with the straight of the material and pin just below edge of curve. Sew one-half inch below this with stab stitch, trim material off close under this stitching. Remove pins. Fit a bias piece of m... To Cover Side Crown
Cut a piece of velvet on a true bias two and one-half inches wider than height of crown. Pin this strip wrong side out around side crown to find length and to locate seam. Draw it snugly and pin seam on straight of material with warp thread. (Warp t...