Toggle navigation
Arts Craft.ca
Home
Making Hats
Kids Craft
Sprung
An uncovered steel wire used to make halo brims; is sometimes sewed on
edge of buckram or other fabric brims, if the hat is unusually wide, or
if a brim is to be especially stiff. It is occasionally used as an edge
wire on wire frames.
Small Wound Rose Of Fabric
Square Crown
More
Raisins
These may be made from gathering a folded circle of plum-colored material one-eighth of an inch from the edge, but used without filling with cotton. Sew to the end of looped tie wire and wind the wire with brown gum tissue. Arrange in a cluster. Alw...
Renovation Of Hat Coverings And Linings
To freshen velvet and raise the pile, brush well to remove the dust. With the wrong side down, hold it over the spout of a tea-kettle of rapidly boiling water. An assistant is needed to brush it lightly as it is passed back and forth over the steam....
Ribbon
A cotton ribbon about three eighths of an inch wide, with a fine wire woven through the center, also a wire on each edge. Used to wire ribbons. ...
Ribbon Covering
If a ribbon is used, it must be gathered on one edge so that it may be drawn down to fit the frame and may be laid on the same as braid. An inch-wide ribbon is easily handled. ...
Ribbon Rose
To make a medium-sized ribbon rose requires two yards of satin ribbon two inches wide. There are several different methods of making the center for this rose. A simple center for this rose may be made from a piece of the ribbon, four inches long. Fo...
Ribbon Rosettes
There are many different kinds of rosettes made from ribbon. Sometimes several loops of ribbon are made very close together and wound with thread as they are gathered. A very pretty rosette is made of narrow ribbon one-quarter of an inch wide. Many ...
Ribbons
If soiled, they may be cleaned in gasoline or soap and water, using a brush. Do not rub or wring. Hang up to drip dry, or wind tightly around a bottle and leave to dry. Do not press until after twenty-four hours, if cleaned in gasoline. To produce e...
Right Sidewrong Side
This stitch is made by taking a long stitch on right side and then a short back stitch on wrong side. Lap ends of crinoline one-fourth inch at finish, but do not turn ends under. ...
Rosettes From Old Plumes
An old plume may be used to make trimming for a hat by cutting it from the quill with a very sharp knife or razor blade, retaining a small portion of the quill which will be sufficient to hold the feathers together. This should be sewed onto a fine ...
Sailor Hat Frame
For convenience we will use the following dimensions: Width of brim, three inches; height of crown, three and one-half inches; length of crown tip, eight and one-half inches; width of crown tip, six and one-half inches, and headsize, twenty-four inc...
Shaped Brim Foundation
The simplest shaped brim is the mushroom style. ...
Sheer Materials
In covering with anything as sheer as georgette, it is advisable to line with some other material first. The color could be made deeper by using a lining of the same color, or made paler by lining with white. The lining should be fitted and sewed on...
Small Wound Rose Of Fabric
Cut from a true bias a strip of material one inch wide and four inches long. Fold lengthwise through the middle. Turn the raw edges in on one end, and gather one-eighth inch from the edge along the raw edges. Draw the thread up to one inch and roll,...
Sprung
An uncovered steel wire used to make halo brims; is sometimes sewed on edge of buckram or other fabric brims, if the hat is unusually wide, or if a brim is to be especially stiff. It is occasionally used as an edge wire on wire frames. ...
Square Crown
A square crown is one having a flat top, or one only slightly rounded, with the sides slightly sloping in towards the top. A crown of this type three or three and one-half inches in height would be at least one and one-half inches smaller at the top...
Square Crown For Wire Frame
Straighten the brace wire and cut four sticks or pieces long enough to reach from the base of the crown at the front up over the proposed crown to the base of the crown at the back, allowing eight inches for finishing. Cut and join a small circle ...
Sticks For Brim
Straighten and cut four pieces of frame wire the length of the diameter of the brim plus three inches for finishing. Place one of these sticks across the headsize wire from front to back on the marks made by the pencil, allowing the ends to extend a...
Straw Shapes
BRIM--Brush well to remove all the dust. If the brim is too wide, a few rows of braid may be removed from the edge, and the edge refinished with one or more rows of ornamental braid of the same color. If it seems necessary to use an edge wire, this ...
Sweet Peas
Cut four petals after the same pattern, making one about one and one-half inches and two one inch, then a small one for the center, or a few knots of baby ribbon may be used for the center. Arrange the petals in a natural-looking blossom. ...
Tailored Bow
This bow is usually made from a piece of ribbon which has both sides alike, although it may be made from any ribbon. A Knox tailored bow is made from gros-grained ribbon. Cut a small piece of buckram for a foundation to sew the ribbon on. This shoul...
Tailored Lining
This lining is rather the most popular lining used. Large firms send their material away to be made up for their trade and the linings may be bought ready-made, but almost every one has pieces of silk which may be easily made into one of these linin...
Tie
Smallest wire used in millinery; comes wound on spools. Is used to tie other wires, and in making hand-made flowers. Comes in black, white, and green. ...
To Color Wire Frames
Wires come in both black and white. A white frame may be colored to match any sheer fabric used for its covering. It will be found to be more simple to color the frame after it is made. Any of the cold or soap dyes may be used. If these are not avai...
To Cover A Close-fitting Or Rolled Brim
Place corner of material on top of brim at front and pin on the edge. Always use the same method of pinning on the edge as given in the first lesson. Draw the material down to the headsize wire and pin. Work the material out smoothly toward the left...
To Cover A Crown With Braid
Begin at the bottom of the crown, slanting the second row off from the first row the same as on the brim. Pull the braid up with the thread (which will be found on the edge of nearly every braid) and sew until the center of the crown tip is reached,...
To Cover A Mushroom-shaped Brim
If not very drooping, it may be covered without making a seam in the material. To do this, begin by placing the corner of the fabric on top at the front of the brim. Pin the front, back, and each side, always pulling with the thread of the material,...