Toggle navigation
Arts Craft.ca
Home
Making Hats
Kids Craft
Lace
Smaller than frame wire, used for wiring lace ribbon and flowers, and
sometimes for making an entire frame when a very dainty design is
desired.
Headsize Wire For Wire Frame
Lace
More
Foundations Of Buckram
The foundation for the second is in the shape of a low pyramid made from buckram. Cut a small circle of buckram, slash in three equally distant places from the outer edge to within one-eighth of an inch of the center. Lap a small amount and sew. Thr...
Frame Or Brace Wire
Used in making frames and is sewed on the edge of all buckram and fabric hat frames. ...
Frames Of Neteen And Crinoline
Lay the pattern on the neteen in such a way as to bring the bias where the greatest amount of roll is to be, then cut making the same allowances as if cut from buckram. This material should be used double to secure the best results. Cut one thicknes...
French Lining
This lining is made from an oval piece of silk which corresponds to the crown measurements. Measure the crown from front to back and from side to side, adding one inch to these measurements. Fit a small wire to the inside of the hat at the headsize ...
Geraniums
These flowers are made of geranium-colored satin ribbon. Use the same method as in making violets, except that yellow stamens should always be added. ...
Grapes
These are made the same as cherries, except a cluster would have several sizes. They are beautiful made from black velvet. A cluster of grapes to sew flat to hat may be made by covering different sizes of button molds and arranging them on a hat to ...
Halo Hat Brims
Halo brims may be made from any fabric, but to be effective the material should be sheer. Malines, nets, georgette crepe, or chiffon are all used to good effect in making this style of hat. Good-looking halo brims have been made from old georgette w...
Hat Frames Of Fabric
Much care, thought, and patience must be exercised in making the frame of any hat. It is the foundation upon which we build, and if poorly made no amount of work can cover it up later. A hat must be right every step of the way. The frame is the firs...
Hat Linings
A hat lining should receive the same careful consideration and workmanship as the outside of the hat. From the milliner's point of view it is an advertisement, the place where we find the designer's name. A well-fitted lining, whether of somber or g...
Headsize Wire
TO MEASURE--This is especially important, for upon the accuracy of this measurement depends the comfort of the wearer; this is the foundation wire. Pass a tape measure around the head over the hair where the hat is to rest and add two inches to this...
Headsize Wire For Halo Brim
This headsize wire is made of frame wire. First measure, then cut, join ends, and shape as for any hat. Lay the headsize wire on the material, having the joining at the back. The front and the back of the brim, if of equal width, will be somewhat na...
Headsize Wire For Wire Frame
A wire frame needs two headsize wires, so cut two just alike, remembering always that the headsize wire is the most important wire in any hat, as the comfort of the wearer depends upon the measurements taken for this wire. Measure as for the headsiz...
Lace
Smaller than frame wire, used for wiring lace ribbon and flowers, and sometimes for making an entire frame when a very dainty design is desired. ...
Lace
Most laces may be washed in warm, soapy water. Press gently in the hands--do not rub. Press the water out after having rinsed the lace well in warm water. Shake gently and pin down smoothly on a sheet, being careful to stretch and pin each scallop i...
Light Straw Hats
Light straw hats may be cleaned by the use of soap and water or gasoline. If the hat is in need of bleaching, sulphur and water may be used, or a commercial bleaching fluid may be bought all ready to use according to printed directions. Two or three...
Malines
Malines may be used to good advantage, even if parts are badly worn and faded. Place a thin, damp cloth over them and press with a warm iron. Allow to dry thoroughly before removing from the ironing-board. ...
Milliner's Fold
Cut from a piece of velvet, satin, or any fabric which is to be used, a bias strip one and one-half inches wide and of the desired length. This must be on a true bias, which is found by placing the warp and woof threads parallel. Any other bias is c...
Morning Glories
Cut a circle of paper four inches in diameter. One quarter section of this will be the pattern for a morning glory. The circle may be larger if desired, but the size should depend somewhat upon the material used. These dimensions are for a small blo...
Mourning Millinery
Hats worn when one is in mourning are nearly always small and made of black crepe with a few folds of white crepe near the face. The covering of crepe is always lined, preferably with sheet wadding to give the soft appearance desired. The trimming i...
Neteen Or Fly Net
A stiff open-meshed material--comes in black, white, and ecru, one yard wide--a very popular material on account of its great pliability and lightness. It is used for blocking frames and copying, the lines being much softer than when made with buckr...
New Brims For Old Crowns
If the brim of a hat is past renewing, a new one may be made, or the wire brim from an old hat may be used with a crown of velvet, or any fabric or straw. The wire brim may be re-covered with georgette--an old, half-worn waist will do nicely, using ...
No 1 Pattern For The Center
This calls for a piece of velvet ribbon one and one-half inches wide and four inches in length. If possible this ribbon should be darker than the darkest petal, but of course should harmonize. Roll the ends and hem them down. Gather along one edge a...
No 2 Pattern For The Center
This center is made from a piece of velvet ribbon three and one-half inches long and one and one-quarter inches wide. Fold lengthwise, with the satin side out. At one end sew straight across, making a seam one-eighth of an inch deep and turn. Cut th...
Old Buckram Frames
When a covered buckram shape has become broken and out of shape, remove all the covering. Dampen the frame and press with a hot iron. A roll of cloth or paper must be held in the hand while pressing the crown. A break in buckram is difficult to remo...