To Glue Velvet To The Brim





When there is a decided roll to a brim, it is sometimes most difficult

to keep the velvet smooth and to make it lie close to the brim, so we

resort to milliner's glue. Do not use glue on satin, or on any fabric

thinner than velvet, or on any frame other than buckram. Care should

always be taken to have the smooth side of the buckram on top when the

velvet is to be glued on.



After fitting the velvet carefully and sewing the seam in the back,

remove the pins from the outer edge and gather the velvet up inside the

headsize where it is to be held while the glue is being spread on the

buckram. The glue must be spread very evenly. It will make a neater job

to glue the seam of the velvet open before going further. Be very

careful to keep the glue away from the right side of the velvet. Next,

rub the glue on the frame with a stiff brush until it is smooth, then

spread the velvet back into place, pressing and smoothing it with the

hands from the headsize wire out. Watch it carefully for any places

which have not sufficient glue, as the material may be raised before it

is dry and more glue added. Do not sew the edge until the glue has

dried. Usually it is only the material on the upper side of the brim

which needs gluing down. The facing may be put on as desired. Sometimes

the top of a crown has indentations, and then the velvet may be glued to

stay in place.



The under or outer facing may be fitted to a rolled or close-fitting

brim more easily than the upper. Beginning at the front with the corner

of the material, pin at the edge and at the headsize wire. Keep the

material smooth; work from right to left, and then from left to right.

Work the material around to where the seam is to be made. Cut away all

superfluous material, allowing three-eighths of an inch for a seam.

Slipstitch together as on the top and finish the edge over wire.

Whenever possible a seam should be made on the straight of the material.





To Freshen Crepe For Mourning Millinery To Join Edge Wire facebooktwittergoogle_plusredditpinterestlinkedinmail

Feedback