To Cover A Close-fitting Or Rolled Brim





Place corner of material on top of brim at front and pin on the edge.

Always use the same method of pinning on the edge as given in the first

lesson. Draw the material down to the headsize wire and pin. Work the

material out smoothly toward the left and pin at the edge; also at the

headsize wire. Then proceed in the same way toward the right, always

pinning closely. Be sure to keep the material tight and smooth both at

edge and at the headsize wire. Allow the fullness to go where it will.

The seam should be located at the center back. Cut away all superfluous

material, allowing three-eighths of an inch seam at the center back.

Turn the raw edges under away from each other at the seam and

slipstitch together neatly.





To Color Wire Frames To Cover A Crown With Braid facebooktwittergoogle_plusredditpinterestlinkedinmail

Feedback