Edge Wire





This is cut from frame wire and must be long enough to reach around edge

of brim and lap one inch. Edge wire is always sewed on same side of brim

as the headsize wire, which is usually the smooth side. Shape this wire

to conform to shape of brim. Never depend on the hat or the stitches to

hold a wire in place. Begin at center-back of hat holding wire toward

you, and sewing from right to left. Hold wire as near the edge as

possible, without letting it slip over the edge. Sew on with overcasting

stitch, taking two stitches in same hole. Take the stitches just the

depth of the wire. If too shallow, the wire will slip off over the edge,

or, if too deep, the wire will slip back away from the edge leaving it

unprotected and liable to become broken and uneven-looking. A frame must

be well made in every detail to produce satisfactory results when

finished.



TO COVER EDGE WIRE--All edge wire must be covered with crinoline or a

cheap muslin. Cut a strip of such goods on a true bias, three-eighths of

an inch wide. Remove the selvage and stretch the strip. Bind the edge

wire with it, holding it very tight. Sew close to wire using a stab

stitch.





Edge Of Brim Facing When Finished Without Wire Edge Wire facebooktwittergoogle_plusredditpinterestlinkedinmail

Feedback