Working Measurements Needed
Make a pencil mark on the pattern around the headsize wire. Before
removing the wire, mark the eight different points where it crosses the
creases in the paper pattern. Remove the wire from the pattern.
More
-
To Slipstitch Seam
Bring needle through edge of fold on one side and enter the needle through edge of fold on other side exactly opposite. Slip needle along in this fold one-eighth of an inch, then bring the needle through to the edge of the fold and take a stitch one... To Straighten Wire
Pass the wire between the thumb and finger with a sweeping motion. A piece of cloth or paper may be held in the hand if the fingers become tender. Do not make small dents in the wire in attempting to straighten it, as it will be impossible to remove... To Tie Wire
Ends of brace wire parallel. Right angles tied diagonally. Brace wire tied without use of tie wire. Before beginning to make a frame of wire, time will be saved and necessary experience gained by tying a few short pieces of wire, until a str... To Wire Turban Flare
Sew the headsize wire one inch from the bottom, being careful not to stretch or full the material. Cut another piece of brace wire one or two inches larger than headsize wire and sew on the raw edge at the bottom, stretching the fabric to fit if a f... Transparent Hats
If a wire frame is to be covered with thin material, great care and thought should be given to the frame, for it then forms part of the design of the hat. A finer wire is sometimes used in this case, or a beautiful frame may be made for thin materia... True Lovers' Knot
This is not, strictly speaking, a bow, but comes under this head. The ribbon used is made into the knot and sewed flat as it is made. It may be sewed on the brim or side crown and is very effective made of gold ribbon. ... Violets
No flower is more popular than the violet, and a cluster of handsome violets make a most acceptable gift at any time. Violet-colored satin ribbon about one-quarter of an inch in width is used. Begin by tying a knot one inch from the end, tie anoth... When Straw Is To Be Re-sewed
Rip carefully from the foundation; brush and press carefully. Some straw will not stand dampening, so try out a small piece first. Place it on a heavily-padded board and press on the wrong side. ... Wild Rose Of Silk
The petals for the wild rose may be cut from the same pattern as for the first rose given. This same pattern is used for many different flowers--the wild rose, apple blossom, sweet pea, and for foliage. For the wild rose use the size having the tw... Willow Plate
A coarse straw-like material, light in weight, brittle, and very expensive, used in blocking; frames are also made from it without blocking. Must be dampened before using. Not recommended for amateurs. WIRE comes in black, white, silver, and ... Wings
Loose feathers should be glued in place and the wing covered with maline or a hair net of the same color. Wings may be covered with a coat of shellac which stiffens them and gives them a very glossy look. ... Wired Ribbon Bows
Ribbon is sometimes wired if a stiff effect is desired. Silk, satin, velvet, or any kind of ribbon can be used. The flat ribbon wire is sometimes pasted between two ribbons with milliner's glue. Often two colors are rather effectively used in this w... Wired Rose
This rose, when carefully made, is most beautiful and sells for an exorbitant price. To make the rose as illustrated requires one-quarter of a yard of satin cut on the bias and one-eighth of a yard of velvet cut on the bias. If the velvet is one or ... Working Measurements Needed
Make a pencil mark on the pattern around the headsize wire. Before removing the wire, mark the eight different points where it crosses the creases in the paper pattern. Remove the wire from the pattern. ...